軟管泵壓輥的調整
泵出廠時，壓輥已按正常情況調整到位，如遇物料吸不上，或在泵的額定壓力下，口量達不到要求，請調整壓輥的偏心距，其步驟如下：
（1）先將泵殼兩側相應的圓孔有機玻璃蓋板與泵出口端的長方形有機玻璃蓋板打開，將轉子壓輥旋轉至兩圓孔之間，其螺栓正對圓孔，然后用套筒扳手將兩端螺栓擰松，再用小圓棒或十字螺絲刀，對準標有0，1，2，3的圓孔，撥動壓輥一側內的偏心套轉動，偏心套的數字越大，其壓輥與泵殼間的距離越小，軟管壓的越緊，其調整是以轉子的頂端的刻線為基準，數字越大，壓的越緊，反之亦然。
（2）調整間隙時一定要注意不要壓的過緊，以達到流量為準，壓的越緊，對膠管的壽命影響越大。

工業軟管泵輸油不足的可能原因及解決方法齒輪泵故障排除10個隔油環齒輪泵應能連續供油，齒輪嚙合重疊系數應大于1。當一對齒輪未脫離嚙合時，另一對齒輪已進入嚙合狀態。這樣，當有兩對齒輪同時嚙合時，兩對齒輪的齒嚙合線之間形成一個封閉的體積，其中部分油也被困在其中。

Possible causes and solutions for insufficient oil delivery of industrial hose pumps. Gear pump troubleshooting. 10 oil-separating ring gear pumps should be able to supply oil continuously, and the gear meshing overlap factor should be greater than 1. When one pair of gears is not disengaged, the other pair of gears has entered the meshed state. In this way, when there are two pairs of gears meshing at the same time, a closed volume is formed between the tooth meshing lines of the two pairs of gears, and part of the oil is also trapped therein.